EasyManuals Logo

Walker MT Detailed Instructions

Walker MT
256 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #207 background imageLoading...
Page #207 background image
Page: 4-73
WALKER MANUFACTURING COMPANY
July 2006
SERVICE INSTRUCTIONS
ADJUSTMENTS - IMPLEMENTS
Perfaerator
Drive Chain Tension
The drive chain should have 1/4 to 1/2 in. (6 to 13 mm)
of slack at midspan. Remove the chain guard cover to
check slack. Adjust the drive chain as follows:
1. Remove the three (3) screws fastening the remov-
able chain guard cover to the frame.
2. Loosen the chain tension block mounting nut and
bolt (see photo below).
3. Position the chain tension block so the chain has
1/4 to 1/2 in. (6 to 13 mm) of slack.
4. Retighten the chain tension block mounting nut
and bolt.
5. Recheck the drive chain tension.
Drive Chain Adjustment
Proper Drive Chain Tension
Tine Ends
Tine ends are adjustable by using the following proce-
dure:
1. Loosen the retaining nut on the tine thread and un-
screw tine end to achieve the desired depth. Open
side of tine should be to rear.
IMPORTANT: Do not unscrew the tine ends too
far. The maximum aerating depth is 2-1/2 in.
(6.35 cm).
2. Tighten retaining nut.
Tine End Depth Adjustment
WARNING
DO NOT attempt to make any adjustments
with the tractor engine running. Disen-
gage the PTO clutch, shut off the machine,
and remove the ignition key. Wait for all
movement to stop before getting off the
seat.
Ref. Chain
Guard
Tension
Block Nut
1/4 to 1/2 in.
(6 to 13 mm)
Slack at
Midspan
Chain Idler
Tine
Opening
to Face
Rear of
Unit
Retaining
Nut
Tine
Opening

Table of Contents

Other manuals for Walker MT

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Walker MT and is the answer not in the manual?

Walker MT Specifications

General IconGeneral
CategoryLawn Mower
ManufacturerWalker
ModelMT
Fuel TypeGasoline
Transmission TypeHydrostatic
Deck MaterialSteel
EngineKohler Command Pro

Related product manuals