Page: 2-30
WALKER MANUFACTURING COMPANY
July 2006
SERVICE INSTRUCTIONS
Ident Lubrication No.
No. Location Type Places
Ident Lubrication No.
No. Location Type Places
Lubrication Points - MB (Start S/N 2004-68441)
1 Deck Caster Wheel Fork Pivot Grease 2
2 Deck Caster Wheel Bearing Grease 2
3 Tee Gearbox, Deck Oil
* 1
4 Blade Drive Gearbox Oil
* 2
5 Universal Joint Shaft Assembly Grease
** 1
6 Deck Support Arm Socket Grease 2
7 Pivot Assembly, Tilt-Up Deck Grease 4
8 Steering Lever Pivot Grease 2
9 Transaxle Oil Reservoir Oil 2
10 Deck-to-PTO Coupling Grease 1
(Grease Slide Area)
11 Universal Joint Tube Assembly Grease
** 1
12 Deck Support Arm Pivot Grease 2
13 Hydro Idler Arm Pivot Grease 1
14 Parking Brake Clevis Oil 1
15 FSC Lever Pivot Grease 1
16 Body Latch Oil 1
17 Parking Brake Lever Oil 2
18 Choke Control Cable Ends Oil 2
19 PTO Belt Tightener Pivot Grease 1
20 Pillowblock Bearing, Drive Shaft Grease
Ī
2
21 Throttle Control Cable Ends Oil 2
22 Engine / Oil Filler Oil
*** 1
23 Choke Control Pivot Oil 1
24 Throttle Control Pivot Oil 1
* Gearboxes are permanently lubricated and sealed requiring
no scheduled lubrication. Oil level should be checked only
when an oil leak is noted.
** Grease every eight (8) hours.
*** Refer to Engine Oil located in this section.
Ī
Sealed, relubricatable-type bearings, grease lightly once per
year, do not over grease or seals will be damaged.
NOTE: DSD42 Tilt-Up Deck is shown for reference. For other
Deck Lubrication Points, refer to Deck and Carrier Frame
Illustrated Parts Manual.
To Next Page
Loading...
Need help?
General
