Page: 2-28
WALKER MANUFACTURING COMPANY
July 2006
SERVICE INSTRUCTIONS
Ident Lubrication No.
No. Location Type Places
Ident Lubrication No.
No. Location Type Places
1 Deck Caster Wheel Fork Pivot Grease 2
2 Deck Caster Wheel Bearing Grease 2
3 Tee Gearbox, Deck Oil
* 1
4 Blade Drive Gearbox Oil
* 2
5 Universal Joint Shaft & Grease
** 1
Tube Assembly
6 Pivot Assembly, Tilt-Up Deck Grease 4
7 Deck Support Arm Socket Grease 2
8 Universal Joint Quick Connect Grease 1
Spline (Grease Slide Area)
9 Ground Drive Belt Idler Arm Grease 1
(not visible - access side of body)
10 Throttle/Choke Control Pivot Oil 1
(on Control Panel) & Cable End
11 PTO Clutch Lever Pivot Grease 3
12 Parking Brake Pivot Oil 1
13 Engine Oil Oil
*** 1
14 Steering Control Linkage Grease 2
15 Tail Wheel Fork Pivot & Grease 2
Wheel Bearing (not shown)
16 Clutch Actuator Push Rod Grease 1
17 Deck Support Pivot Arm Grease 2
* Gearboxes are permanently lubricated and sealed requiring
no scheduled lubrication. Oil level should be checked only
when an oil leak is noted. Refer to Mower Deck Gearbox
Lubrication in this section.
** Lubricate every eight (8) hours.
*** Refer to Engine Oil in this section.
NOTE: DSD42 Deck is shown for reference. For other Deck
Lubrication Points, Refer to Deck and Carrier Frame
Illustrated Parts Manual.
Lubrication Points - MW
To Next Page
Loading...
Need help?
General
