Page: 1-12
WALKER MANUFACTURING COMPANY
July 2006
SERVICE INSTRUCTIONS
Installing PTO Quick Coupler
Coupler Ring “Locked” Position
5. Pull out counterweight spring receptacle assist
handle and lift up on locking finger slightly to unlock
the receptacle assembly. Lower this assembly to-
ward the deck and attach the counterweight
springs to the receptacle. Raise the assist handle
until the assembly locks into the raised position to
tension the springs.
Counterweight Spring Receptacle Assembly in
"Unlocked" Position
Counterweight Spring Receptacle Assembly in
"Locked" Position
6. With the counterweight springs connected, the
weight on the deck caster wheels should be 15 to
25 Ib (7 to 11 kg). Check this weight by lifting on the
front of the deck carrier frame. If required, the
spring tension can be adjusted by tightening or
loosening the elastic stop nuts located underneath
the lower spring hook.
Pull Back Spring-Loaded
Coupler Ring
Spring-Loaded Coupler Ring
In Fully Forward Position
3) Use Lever to Assist
Raising Assembly to
"Locked" Position
2) Retain Spring Clip
Using Tab
1) Install Counterweight
Spring Clip
into Receptacle
Locking Finger "Snaps"
to Hold Assembly in
"Locked" Position
Lift Up on Locking
Finger to Lower
Assembly
To Next Page
Loading...
Need help?
General
