Button Action/result
Press ok and do the same for the upper limit position.
The following menu is displayed.
NOTE If the procedure was not successful, leave the menu
and start again.
Press ok.
The [Limit positions / run time] menu opens again.
NOTE The procedure described here as an example is for the "tubular motor" prod-
uct. Depending on the product type, the menus and instructions provided by
the WMS Central transmitter may vary from the procedure described here.
For the "external venetian blind" product, a further menu item appears for tilt-
ing the slats.
Follow the instructions of the WMS Central transmitter on the screen.
System
To Next Page
Loading...
