61
8.1.3 Operating products by
recalling scenes
Scenes can be used to jointly operate a large number of different products at
the press of a button. The position or activation state of the products involved
is stored and is then brought about again when the scene is recalled.
To recall a scene:
button Action/result
In the main menu, press the function button repeatedly until
the selection cursor is on the [Products] line.
Press the ok button.
The [Select product type] menu opens.
Using the function buttons, select [Scenes].
Press the ok button.
All stored scenes are displayed.
Using the function buttons, select the scene that you would
like to recall.
Press the button briefly.
All products involved in the scene move to their stored posi-
tions.
The status display indicates the transmission process:
GREEN: The central transmitter is transmitting
RED: The command is not confirmed (e.g. the receiver is
outside of the transmission range)
To change a scene:
Move the products involved in the scene to the desired posi-
tions.
Press the
button until the status display shows the trans-
mission process.
The scene is stored again.
Main menu
Products
Scenes
Products
To Next Page
Loading...
