9.1.3 Settings
This menu gives you access to all actuator parameters.
CAUTION
Change the safety-related parameters (e.g. wind speed limit) only if you have
the knowledge necessary to do so and have been trained in the special
features of the particular sun shading product you are using. Incorrect limit
values can result in damage to the sun shading product.
NOTE The parameters are charged directly from the actuators. Some of the dis-
played parameters may vary with the type of actuators and product type.
The parameters displayed in this chapter relate to the example of an external
venetian blind.
The [Settings] menu with its submenus is displayed as follows.
button Action/result
In the main menu, select the [System] menu and press ok.
The [System] menu opens.
Select the [Products] menu here and press ok.
The [Select product type] menu opens.
Using the selection cursor, select the product type of the
desired channel.
Press the ok button.
All channels of the selected product type are displayed.
Using the selection cursor, select the desired channel.
Press the ok button.
The context menu for the selected channel is displayed.
Main menu
System
Products
Product type
Channel x
Settings
System
To Next Page
Loading...
