2
GENERAL INFORMATION
2.4 RECEIVING AND STORAGE
The MVW01 is supplied with the power arms separated from the cabinet and packed individually. The packing is made of an OSB frame and
polystyrene foam wedges. There is an identification label outside this package, which is identical to the one attached to the arms. Confront
the content of this label with the purchase order. In order to open the arm packages, refer to the procedure described in the Item 10.1.5
Unpacking on page 10-3 .
If the MVW01 arms are not installed soon in the cabinet, store them in a clean and dry environment (temperature between -20°C and 50°C (-4
and 122 °F) and moisture below 80 %) covered up in order to avoid dust accumulation or water splashing. It is recommended to replace the
silica gel every three months.
The MVW01 has a dehumidifier module, which must remain turned on in case of storage for over thirty days.
The MVW01 panel is supplied in a package composed of cardboard and wood. The guidance for handling, transportation, mechanical and
electric installation is presented in the Chapter 10 INSTALLATION, CONNECTION AND ENERGIZATION on page 10-1 and in Item 10.1.5
Unpacking on page 10-3 .
WARNING!
It is very important to check that the inverter software version is the same as indicated on the first page of this manual.
MVW01 | 2-16
To Next Page
Loading...
