EasyManuals Logo

Wintriss WPC 1000 User Manual

Wintriss WPC 1000
235 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #100 background imageLoading...
Page #100 background image
Initialization, Setup, and Checkout 3-1
Chapter 3. Initialization, Setup, and
Checkout
This chapter shows you how to initialize and set up your WPC 1000 and perform final
checkout tests.
Viewing and Setting Press Parameters
The WPC 1000 allows you to view and, in some cases, to set up to ten press parameters, the
number of items depending on the WPC 1000 display option you have ordered. On the
standard WPC 1000 display, you can access the following items:
Crankshaft angle or strokes per minute (SPM)
Stopping time
90° stop time test result
Stopping angle
Top-stop angle
Stop-time limit
Auto carry-up angle
Micro-inch time setting
OPERATOR STATION WIRED INCORRECTLY
Run all necessary tests to verify that each Operator Station is wired correctly and provides proper
anti-tie-down and anti-repeat protection.
Failure to comply with these instructions will result in death or serious injury.
MORE OPERATORS THAN OPERATOR STATIONS
Ensure that there are the same number of active operator stations as there are operators if the
press is not equipped with properly installed and operating light curtains.
During setup, lockout/tagout the press if there are more operators than operator stations.
Verify at every shift change that there are the same number of active operator stations as there
are operators if the press is not equipped with properly installed and operating light curtains.
Failure to comply with these instructions will result in death or serious injury.
TWO-HAND CONTROL TOO CLOSE TO HAZARDOUS AREA
Verify at each shift change that any moveable Two-hand controls are located at least the safety
distance from the pinch point or hazardous area.
Failure to comply with these instructions will result in death or serious injury.
DANGER
!
DANGER
!
DANGER
!

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Wintriss WPC 1000 and is the answer not in the manual?

Wintriss WPC 1000 Specifications

General IconGeneral
BrandWintriss
ModelWPC 1000
CategoryController
LanguageEnglish

Related product manuals