1125100 WPC 1000 User Manual
I-4 Index
start time
fault (loss of rotation)
,5-15
initializing the start-time limit,3-4, 3-5
viewing the start-time limit,3-6
stop time
allowance for brake wear (Tbm)
,3-16
calculating the stop-time limit,3-16
determining stop time at 90° (continuous),3-18
determining stop time at 90° (single-stroke),3-19
determining stop time at top-stop,3-15
enabling changes to stop-time limit,3-31
initializing stop-time limit,3-4
setting stop-time limit,3-17
stop time exceeded fault,5-4
stopping time
using in ANSI safety distance formula
,3-22
using in OSHA safety distance formula,3-24
stroke select key switch
installing and wiring (display board kit)
,2-54
installing and wiring (panel mount),2-51
location and function,1-1
suppressor, installing across an AC load,2-38
system static test,3-40
–T–
tests
checkout
,3-35
installation verification,2-65
ninety degree (90°) stop time,3-18
top-stop "on" angle
adjusting
,3-12
determining,3-7
setting,3-7, 3-27
top-stop button (operator station)
location
,1-3
testing top-stop circuit,3-37
top-stop bypass, operating the press in,4-8
top-stop in inch
disabling
,2-33
operating the press in,4-8
top-stop mode for F and H errors, setting,3-31
two-hand mode
operating the press in continuous two-hand
,4-15
operating the press in single-stroke two-
hand
,4-10
–U–
user inputs
faults
,5-12
testing,3-54
wiring,2-28
–W–
wiring connections
auxiliary output 1
,2-30
bar control,2-45
cam output assembly,2-36
control board (TB101 and TB102),2-69
DSV/lockout relay board,2-70
foot switch,2-40
lockout relay,2-30
micro-inch,2-33
mute lamp,2-54
one-hand control,2-44
overrun sensor switch,2-27
power (J103),2-70
remote reset switch,2-34
reset button,2-54
resolver (TB103),2-70
selector switches,2-51
settings key switch,2-54
user inputs,2-29
zero cam,2-39
–Z–
zero cam, wiring output to AutoSet,2-39
To Next Page
Loading...
Need help?
General
