July 2019
4-36
Xerox® B210 Service Manual
REP 4.15
Initial Release
Repairs - Adjustments
7. Remove the following items, Figure 2:
CAUTION
Note the order the Feed and Registration Drive Gears are removed for correct installation
during t
he replacement procedures.
a. Remove the snap-ring, then remove the Feed and Registration Drive Gears.
b. Remove two snap-rings, then remove two Feed and Registration Clutch Bushings.
c. Remove two screws, release the latch, the remove the Exit Drive Gears.
Figure 2 Drive Gears and Bushings
8. Remove the following from the left frame, F
igure 3:
a. Release two latches, then remove two Shaft Bushings.
b. Remove two screws securing the LSU support.
c. Remove five screws securing the Middle Frame and Pickup Frame Base.
Figure 3 Frame Screw Removal
Snap Ring
Exit Drive Gears
Feed & Registration Drive Gears
Clutch Bushings
Step 8b
Step 8c
Step 8c
Step 10
Step 8a
To Next Page
Loading...
