Xerox C75 User Manual

5. Select Keyboard, then in the New System Administrator Login ID entry field, type a
system administrator ID.
6. Select Save.
You must reenter the login ID information a second time.
7. Select Keyboard once more, and in the Re-enter System Administrator Login ID field,
type the same system administrator ID.
8. Select Save.
9. Exit administrator mode.
System Administrator Passcode
Set the passcode for the system administration mode. The passcode is used to access
the control panel when Passcode Entry from Control Panel is set to On. A passcode must
be entered for local account login. However, a passcode must always be entered when
accessing either remotely or from the network.
Tip
This is recommended for stronger security.
Note
The default setting of the system administrator passcode is 1111.
Set the password AFTER setting the system administrator UserID. The passcode must
be 4-12 characters.
1. Login as administrator.
2. Access the Tools tab on the UI.
3. Select Authentication/Security Settings > System Administrator Settings > System
Administrator Passcode.
4. Select Keyboard.
5. Type the new password from 4-12 numeric digits in the New Passcode field.
6. Select Save.
Note
To set no passcode, leave the passcode blank, and select Save.
7. In the Re-enter Passcode field, retype the same password.
8. Select Save.
9. Exit administrator mode.
Authentication
Use the Authentication menu options to setup the login, access control and user
accounts.
21-3Xerox
®
Color C75 Press
System Administration Guide
Authentication/Security Settings

Xerox C75 Specifications

General

Print Resolution	2400 x 2400 dpi
Duplex Printing	Yes
Printer Type	Color Laser
Print Speed	75 ppm
Monthly Duty Cycle	Up to 300, 000 pages
Paper Capacity	Up to 5, 900 sheets
Connectivity	Ethernet, USB 2.0
Display	Touchscreen