Xerox C75 User Manual

Configuration of Job Flow Sheets
This section describes how to configure the machine to use the Job Flow Sheets service.
Enabling the ports and setting up TCP/IP
In order to use the Job Sheets service, enable the SOAP port, SNMP port, and Internet
service port, and set IP addresses. The procedure for setting the machine follows.
Note
The configuration can also be performed using CentreWare Internet Services. Refer to
Using CentreWare Internet Services.
1. Enter the System Administrator Mode.
2. Enable the SOAP port.
a) Select System Settings.
b) Select Connectivity & Network Setup.
c) Select Port Settings.
d) Select SOAP and then select Change Settings.
e) Select Port Status and select Change Settings.
f) Select Enable and then select Save.
g) Select Close until the Port Settings window displays.
3. Enable the SNMP port.
a) Select SNMP and then select Change Settings.
b) Select Port Status and select Change Settings.
c) Select Enabled and then select Save.
d) Select Close until the Port Settings window displays.
4. Enable the Internet service (HTTP) port as above.
5. Select Close until the Tools window displays.
6. If necessary, set the IP Address.
7. Select Close until the System Settings screen displays.
8. Exit the System Administrator Mode.
9. After the machine is restarted, print out the Configuration Reports to confirm that
the SOAP, SNMP, and Internet Services (HTTP) ports are enabled and that TCP/IP is
set up correctly.
Configuring the SNMP port
Configure the transport protocol for the SNMP port using CentreWare Internet Services.
1. Start a web browser.
2. Enter the machine’s IP address or the Internet address to the address entry column
on the browser, and press the Enter key.
Xerox
®
Color C75 Press7-14
System Administration Guide
Using the Scan Service

Xerox C75 Specifications

General

Brand	Xerox
Model	C75
Category	All in One Printer
Language	English