7. Next to Split Encrypted E-mail for Each Recipient, select Enabled to split an encrypted
email addressed to multiple recipients into individual encrypted emails addressed to
each of the recipients.
Note
When an encrypted email is split for each recipient, it will only be sent to recipients
with a valid email address. Print a transmission report to see delivery status.
8. Click Apply.
IPsec
Internet Protocol Security (IPsec) is a group of protocols used to secure Internet Protocol
communications by authenticating and encrypting each IP data packet. It allows you
to control IP communication by creating protocol groups, policies, and actions for the
following:
• DHCP v4/v6 (TCP and UDP)
• LPR Print (TCP port 515)
• DNS (TCP and UDP)
• Port 9100 Print (TCP port 9100)
• FTP (TCP)
• SMTP (TCP/UDP port 25)
• HTTP (Scan Out, TCP port 80)
• SNMP (TCP/UDP port 161)
• HTTPS (Scan Out, TCP port 443)
• SNMP Traps (TCP/UDP port 162)
• HTTPS (Web Server, TCP port 443)
• WS-Discovery (UDP port 3702)
• ICMP v4/v6
• Up to 10 additional services
• IPP (TCP port 631)
Configuring IPSec
Note
Secure HTTP (SSL) must be enabled with an installed digital certificate before you can
enable IPsec.
1. In CentreWare IS, click Properties > Security > IPSec.
2. Next to Protocol, select Enabled.
3. Select the IKE Authentication Method, Preshared Key or Digital Signature.
4. If you select Preshared Key, type the Shared Key and retype the key to verify.
5. Type the IKE SA Life Time (5-28800 minutes).
6. Type the IPSec SA Life Time (300-172800 minutes).
7. Select the DH Group type.
22-21Xerox
®
Color C75 Press
System Administration Guide
Using CentreWare Internet Services for Accounting and Authentication / Security
To Next Page
Loading...
Need help?
General
