• Do not use adhesive pellets that have fallen on the floor as they may contain dirt
and dust which may cause binder malfunctions.
• Do not place anything other than the adhesive pellets into the adhesive replenishment
hopper as this may cause a fire in the binder.
• The adhesive pellets are transferred to the binder as the supply in the binder is
consumed. The binder can contain about 0.8 pounds (380 grams) of adhesive.
Replenishing the adhesive filling tray
1. Open the adhesive filling tray.
2. Open the outer cover.
3. Open the inner cover.
4. Using the supplied scoop, add adhesive pellets to the replenishment hopper until the
height of the pellets is even and level and just below the adhesive limit line.
5. Close the inner and outer covers.
6. Close the adhesive filling tray; an audible click is heard when the tray locks into
position.
Binder problem solving
Note
• Paper jams are displayed on both the printer’s UI and the binder’s control panel.
• Clear multiple paper jams in the sequence indicated on the printer’s UI and on the
binder’s control panel.
16-27
Xerox
®
Color 800/1000 Press
User Guide
Perfect Binder
To Next Page
Loading...
