Why Xerox CopyCentre 133 Copier will not power on?
If your Xerox Copier doesn't power on, try these steps: First, check the power cord to make sure it's properly connected. Then, verify that the power switch is in the ON position. Next, look at the RESET button on the back of the copier; if it's popped up, push it to reset. Finally, ensure the AC outlet is supplying power by plugging another device into it.
What to do if Xerox CopyCentre 133 Copier prints blank output?
If your Xerox Copier produces blank output, ensure the document is loaded face up in the document feeder. If you've just installed a new drum cartridge, the toner might not be dispensing yet; try the job again. Also, verify that the seal tape has been removed from the new drum cartridge. Try reinstalling both the drum and toner cartridges. If problems persist, replace the drum cartridge, or replace the toner cartridge if the screen indicates it's time.
How to fix streaks, solid or dotted lines, or spots on Xerox CopyCentre 133 Copier output?
To address streaks, solid or dotted lines, or spots on your Xerox Copier output, start by cleaning the document glass, CVT glass, areas under the platen cover, the document feeder, and the paper guides. If the copier has been idle for a while, or if the toner or drum cartridge is new, try running the job again. You can also try using the document glass instead of the feeder. Reinstall the drum cartridge. Check the quality of the original document and use the Border Erase feature to remove any unwanted lines or marks from the edges. Load fresh paper and check the humidity of the room where the copier is located.
Why Xerox Copier document feeder will not feed?
If the document feeder on your Xerox Copier isn't working, make sure it's not overloaded; it can only hold up to 50 sheets. Also, check that the document is fully inserted into the feeder.
Why Xerox Copier is printing output too light or too dark?
If your Xerox Copier's output is too light or too dark, try loading fresh paper and check the quality of the original document. You can also adjust the darkness settings on the touch screen by selecting [Lighten/Darken]. Try running off a few more prints to see if the copy quality improves. If the problem persists, consider replacing the drum cartridge.
Why Xerox CopyCentre 133 is producing blurred images?
If your Xerox Copier is producing blurred images, try loading fresh paper. If the issue persists, replace the drum cartridge or the toner cartridge, especially if the screen prompts you to do so.
What to do if Xerox Copier displays a memory full error message?
If your Xerox Copier shows a memory full error, first check with the Key Operator about available memory. If the memory is indeed full, divide the remaining pages of your print job into smaller sections and run them separately.
What to do if Xerox CopyCentre 133 paper delivered to an output tray is not properly stacked up?
If paper isn't stacking properly in the output tray of your Xerox Copier, try flipping the paper stack over in the paper tray or rotating it head to toe.
Why Xerox CopyCentre 133 is displaying a tray fault?
If your Xerox Copier is displaying a tray fault, try opening the paper tray and adjusting the paper tray guides. First, move the guides away from the paper, and then move them back against the paper so they're just touching it. If this doesn't solve the problem, power the machine off and then on again.
How to fix uneven print on Xerox CopyCentre 133 Copier?
To fix uneven printing on your Xerox Copier, try replacing the drum cartridge. If the screen displays a message to replace the toner cartridge, replace it as well.
To Next Page
General
