Xerox CopyCentre 133 User Manual

Print Mode Settings
Xerox CopyCentre/WorkCentre/WorkCentre Pro 123/128/133 User Guide 221
Allocate Memory
Use this feature to specify memory capacities required for printing and for the receive
buffer for each interface.
1. Select [Allocate Memory] on the
[Print Mode Settings] screen.
2. Use the scroll buttons to switch
between screens.
3. Perform the necessary
operations.
4. Select [Close].
PostScript Memory
Allows you to change the PostScript memory capacity within the range of 8.00–96.00
MB in 0.25 MB increments using the scroll buttons or the numeric keypad. The currently
available memory will be displayed at the top of the screen with the following message:
“Memory Available: XXX MB.”
Receiving Buffer - Parallel
Allows you to change the input buffer memory capacity when using the parallel port
within the range of 64–1,024 KB in 32 KB increments using the scroll buttons or the
numeric keypad. The currently available memory will be displayed at the top of the
screen with the following message: “Memory Available: XXX MB.”
Receiving Buffer - USB
Allows you to change the input buffer memory capacity for USB interface within the
range of 64–1,024 KB in 32 KB increments using the scroll buttons or the numeric
keypad. The currently available memory will be displayed at the top of the screen with
the following message: “Memory Available: XXX MB.”
Receiving Buffer - LPD Spool
Allows you to change the input buffer memory capacity for LPD interface. The currently
available memory will be displayed at the top of the screen with the following message:
“Memory Available: XXX MB.”
Off
Allows you to change the memory capacity within the range of 1024–2048 KB in 32 KB
increments using the scroll buttons or the numeric keypad.
Memory
Allows you to change the memory capacity within the range of 0.50–32.00 MB in 0.25
MB increments using the scroll buttons or the numeric keypad.

Xerox CopyCentre 133 Specifications

General

Brand	Xerox
Model	CopyCentre 133
Category	Copier
Language	English