Xerox CopyCentre 133 User Manual

11 Setups
222 Xerox CopyCentre/WorkCentre/WorkCentre Pro 123/128/133 User Guide
Hard Disk
Specifies the spool location to the hard disk.
Receiving Buffer - NetWare
Allows you to change the input buffer memory capacity for NetWare interface within the
range of 64–1,024 KB in 32 KB increments using the scroll buttons or the numeric
keypad. The currently available memory will be displayed at the top of the screen with
the following message: “Memory Available: XXX MB.”
Receiving Buffer - SMB Spool
Allows you to change the input buffer memory capacity for SMB interface. The currently
available memory will be displayed at the top of the screen with the following message:
“Memory Available: XXX MB.”
Off
Allows you to change the memory capacity within the range of 64–1,024 KB in 32 KB
increments using the scroll buttons or the numeric keypad.
Memory
Allows you to change the memory capacity within the range of 0.50–32.00 MB in 0.25
MB increments using the scroll buttons or the numeric keypad.
Hard Disk
Specifies the spool location to the hard disk.
Receiving Buffer - IPP Spool
Allows you to change the input buffer memory capacity for IPP interface. The currently
available memory will be displayed at the top of the screen with the following message:
“Memory Available: XXX MB.”
Off
Allows you to change the memory capacity within the range of 64–1,024 KB in 32 KB
increments using the scroll buttons or the numeric keypad.
Hard Disk
Specifies the spool location to the hard disk.
Receiving Buffer - Ethertalk
Allows you to change the input buffer memory capacity for Ethertalk interface within the
range of 1,024–2,048 KB in 32 KB increments using the scroll buttons or the numeric
keypad. The currently available memory will be displayed at the top of the screen with
the following message: “Memory Available: XXX MB.”

Xerox CopyCentre 133 Specifications

General

Brand	Xerox
Model	CopyCentre 133
Category	Copier
Language	English