Xerox CopyCentre 133 User Manual

11 Setups
212 Xerox CopyCentre/WorkCentre/WorkCentre Pro 123/128/133 User Guide
Network Settings
This screen allows you to change the default settings for the network configuration.
There are eight main setup options available. For more information, refer to the
following.
NOTE: Items shown in these setting screens may vary depending on a usage
environment.
For more information on network setups, refer to the System Administration Guide.
Port Settings – page 212
Protocol Settings – page 215
Machine E-mail Address/Host Name – page 216
POP3 Server Settings – page 217
SMTP Server Settings – page 218
Domain Filter – page 219
Remote Authentication Server Settings – page 219
Other Settings – page 220
1. Select [Network Settings] on the
[System Settings] screen.
2. Select the required option.
3. Select [Close].
Port Settings
This feature allows you to set print mode, port status, communication mode, auto eject
time for each communication port.
1. Select [Port Settings] on the
[Network Settings] screen.
2. Perform the necessary
operations.
3. Select [Close].
Parallel
Use this feature to specify whether to enable the parallel port and to configure the
relative parameter settings.
Port Status
Specify whether to enable the parallel port.

Xerox CopyCentre 133 Specifications

General

Brand	Xerox
Model	CopyCentre 133
Category	Copier
Language	English