Xerox CopyCentre 133 User Manual

11 Setups
224 Xerox CopyCentre/WorkCentre/WorkCentre Pro 123/128/133 User Guide
Unregistered Forms
Sets whether to abort a job which is specified to use form overlay when the form is not
found (not registered) in the machine.
Banner Sheet
Sets whether to add sorting sheets (banner sheets). This is effective for sorting/
classifying to differentiate printed sheets from the rest. You can add banner sheets
before and/or at the end of the print job.
NOTE: Even if using the Finisher, banner sheets will not be stapled.
Banner Sheet Tray
Specifies a tray for the banner sheets.
PostScript Paper Supply
Sets whether to use the DMS (Deferred Media Selection) feature of PostScript.
PostScript Font Absence
Sets to replace the font automatically and continues the print job when the required font
is not found.
NOTE: This feature is available only when PostScript is loaded.
PostScript Font Substitution
Sets whether to use ATCx for font replacement.
NOTE: This feature is available only when PostScript is loaded.
Scan Mode Settings
This screen allows you to configure or change machine settings specific to the scan
features. For more information, refer to the following.
Scan Defaults – page 225
Scan-to-FTP/SMB Defaults – page 226
Scan Size Defaults – page 226
Output Size Defaults – page 227
Reduce/Enlarge Presets – page 228
Other Settings – page 228
1. Select [Scan Mode Settings] on
the [System Settings] screen.
2. Select the required option.
3. Select [Close].

Xerox CopyCentre 133 Specifications

General

Brand	Xerox
Model	CopyCentre 133
Category	Copier
Language	English