Xerox Color 800 User Manual

6. Reinstall the cartridge unit to its original position in the finisher.
7. Close the Right Cover on the finisher.
Note
A message will display and the machine will not operate if the right cover is open
even slightly.
Standard Finisher Plus fault codes
Finisher Module fault codes
If an error code appears that is not listed in the table below, or if an error persists after
following the listed solution, then contact your Xerox Customer Support Center.
Recommended solutionPossible causeFault code
• Check for any obstructions or
paper jams in the Finishing
Module and Finishing Transport
paper paths and clear them.
• If necessary, power Off/On the
machine, and if necessary,
resend/restart your print job.
• If the fault persists, contact the
Customer Support Center.
The transport in sensor in
the Finishing Transport did
not switch ON within a
specified amount of time.
013 108
The transport exit sensor
in the Finishing Transport
did not switch ON within a
specified amount of time.
013 109
The transport exit sensor
in the Finishing Transport
did not switch OFF within
a specified amount of
time.
013 110
Paper jam at the transport
in sensor (Finishing
Transport)
013 910
Paper jam at the transport
exit sensor (Finishing
Transport)
013 911
19-39
Xerox
®
Color 800/1000 Press
User Guide
Standard Finisher Plus

Xerox Color 800 Specifications

General

Brand	Xerox
Model	Color 800
Category	Copier
Language	English