Phaser 3300MFP Service Manual 8-37
Service Parts Disassembly
Pick Up Roller Shaft
To allow better access to the parts, lay the machine on its back. Refer to
“Laying the Unit on its Back” on page 8-4.
To remove the Pick Up Roller Shaft:
1. Release the lock and slide the shaft to the right.
2. Lift the latch on the cam to release it from the notch in the shaft.
3. Slide the cam and the bushing from the shaft, then remove the shaft from
the Duplex Guide Housing, as shown below.
s3300mfp-122
2
1
3
4
Cam
Bush
Lock
Shaft
To Next Page
Loading...
