Xerox WorkCentre 3615

Faxing
Configuring Fax Transmission Defaults from the Control Panel
1. At the printer control panel, press the Machine Status button.
2. Touch Tools > Admin Settings.
3. Touch Fax Settings.
4. Touch Transmission Defaults.
5. To configure the printer to auto redial a busy number or a line that does not answer:
a. Touch Auto Redial Setup.
b. To change the number of redial attempts, touch Number of Redial, enter a number from 0–9,
then touch OK.
c. Touch OK.
d. At the Restart System prompt, touch Close.
6. To change the interval between the redial attempts:
a. Touch Redial Interval, then enter a number from 1–15 for the delay in minutes.
b. Touch OK.
c. At the Restart System prompt, touch Close.
7. To change the interval between resend attempts:
a. Touch Interval Timer, then enter a number from 3–255 for the delay in seconds.
b. Touch OK.
c. At the Restart System prompt, touch Close.
d. Touch the Back arrow to return to Transmission Defaults.
8. To select the dialing type for your outgoing faxes:
a. Touch Dial Type.
b. Select an option:
• PB uses push-button tone dialing.
• DP (10 PPS) sets 10 pulse per second dialing pulses as the dial type.
• DP (20 PPS) sets 20 pulse per second dialing pulses as the dial type.
110 Xerox
®
WorkCentre
®
3615 Black and White Multifunction Printer
System Administrator Guide