Xerox WorkCentre M20 - Page 126

December 2006
4-28
WorkCentre M20, 4118, FaxCentre 2218 Family
REP 5.1
Repairs and Adjustments
11. Remove the MEA unit support pick up assembly, Figure 10.
Figure 10 MEA unit support pick up assembly removal
12. Remove the MEA unit - pickup, Figure 11.
Figure 11 MEA unit - pickup removal
13. Prepare to remove the guide - M scan assembly, Figure 12.
Figure 12 Preparation
2
Remove the MEA unit support pick
up assembly. Then disconnect the
spring.
1
Remove 2 screws.
2
Remove 1 E-clip, then the
MEC clutch small (feed).
4
Remove 1 E-clip, 1bearing,
then the MEA unit - pickup.
1
Disconnect the inline con-
nector.
3
Remove 1 E-clip, then the
bearing.
1
Disconnect CN2.
2
Disconnect 2 ground
harnesses.
3
Disconnect ELA HOU -
cover open switch inline
connector.