Xilinx Zynq UltraScale+ ZCU216 - Sd

SD
Use the following steps to boot from an SD card.
1. Store a valid Zynq UltraScale+ RFSoC boot image le onto an SD card (plugged into SD
socket J23) connected to the MIO[39:51] SD interface.
2. Set the boot mode pins SW3 [4:1] as indicated in the table above for SD.
3. Either power-cycle or press the power-on reset (POR) pushbuon. SW2 is callout 11 in
Figure 3.
See the Zynq UltraScale+ Device Technical Reference Manual (UG1085) for more informaon about
Zynq UltraScale+ RFSoC conguraon opons.
Chapter 2: Board Setup and Configuration
UG1390 (v1.1) July 10, 2020 www.xilinx.com
ZCU216 Board User Guide 21
Send Feedback