Xilinx Zynq UltraScale+ ZCU216 User Manual

PL C0 I/F DDR4 Component Memory
[Figure 2, callout 3]
The 4 GB, 32-bit wide DDR4 memory system is comprised of four 1 Gb x 8 SDRAM (Micron
MT40A1G8WE-075E), U96-U99. This memory system is connected to PL-side ZU49DR banks
64 and 65. The DDR4 0.6V PL_DDR4_C0_VTT terminaon voltage is supplied from IR3897 sink-
source regulator U79.
• Manufacturer: Micron
• Part Number: MT40A1G8WE-075E
• Descripon:
○ 8 Gb (1 Gb x 8)
○ 1.2V 78-ball FBGA
○ DDR4-2666
The ZCU216 ZU49DR RFSoC PL DDR interface performance is documented in the Zynq
UltraScale+ RFSoC Data Sheet: DC and AC Switching Characteriscs (DS926).
The ZCU216 board DDR4 32-bit component memory interface adheres to the constraints
guidelines documented in the PCB guidelines for DDR4 secon of UltraScale Architecture PCB
Design User Guide (UG583). The ZCU216 DDR4 component interface is a 40Ω impedance
implementaon. Other memory interface details are also available in the UltraScale Architecture-
Based FPGAs Memory IP LogiCORE IP Product Guide (PG150).
For addional details, see the Micron MT40A1GWE-075E data sheet on the Micron Technology
website.
The detailed RFSoC connecons for the feature described in this secon are documented in the
ZCU216 board XDC le, referenced in Appendix B: Xilinx Design Constraints.
PL C1 I/F DDR4 Component Memory
[Figure 2, callout 4]
The 4 GB, 32-bit wide DDR4 memory system is comprised of four 1 Gb x 8 SDRAM (Micron
MT40A1G8WE-075E), U100-U103. This memory system is connected to PL-side ZU49DR banks
68 and 69. The DDR4 0.6V PL_DDR4_C1_VTT terminaon voltage is supplied from IR3897 sink-
source regulator U80.
• Manufacturer: Micron
• Part Number: MT40A1G8WE-075E
Chapter 3: Board Component Descriptions
UG1390 (v1.1) July 10, 2020 www.xilinx.com
ZCU216 Board User Guide 27
Send Feedback

Xilinx Zynq UltraScale+ ZCU216 Specifications

General

Brand	Xilinx
Model	Zynq UltraScale+ ZCU216
Category	Motherboard
Language	English