Xilinx Zynq UltraScale+ ZCU216 - I2 C1 TCA9548 A U22 Target Device Addresses; Uart0 (Mio 18-19); FT4232 HL Port Assignments

Table 11: I2C1 TCA9548A U20 Target Device Addresses (cont'd)
TCA9548A U20 (Addr 0x74) Port I2C1 Bus Device Target Device Address
7 No Connection NA
Table 12: I2C1 TCA9548A U22 Target Device Addresses
TCA9548A U22 (Addr 0x75) Port I2C1 Bus Device Target Device Address
0 FMCP HSPC J28 0x##
1 USER Si570 C1 Clock U130 0X5D
2 SYSMON U1 BANK 65 0x32
3 PS DDR4 SODIMM SKT. J48 0x51
4 SFP3 P3 0x50
5 SFP2 P2 0x50
6 SFP1 P1 0x50
7 SFP0 P0 0x50
For more informaon on the TCA9548A, TCA6416A, and PCA9544A, see the Texas Instruments
website.
The detailed Zynq UltraScale+ RFSoC connecons for the feature described in this secon are
documented in the ZCU216 board XDC le, referenced in Appendix B: Xilinx Design Constraints.
UART0 (MIO 18-19)
[Figure 2, callout 8]
This is the primary Zynq UltraScale+ RFSoC PS-side UART interface and is connected to the FTDI
U29 FT4232HL USB-to-Quad-UART Bridge port B through TXS0108E level-shier U32.
The FT4232HL U29 port assignments are listed in the following table.
Table 13: FT4232HL Port Assignments
FT4232HL U29 Zynq UltraScale+ RFSoC U1
Port A JTAG ZCU216 JTAG Chain
Port B UART0 PS_UART0 (MIO 18-19)
Port C UART2 PL_UART2 Bank 89
Port D UART3 U38 System Controller UART
The FT4232HL interface circuit connecvity is shown in the following gure.
Chapter 3: Board Component Descriptions
UG1390 (v1.1) July 10, 2020 www.xilinx.com
ZCU216 Board User Guide 35
Send Feedback