Xilinx Zynq UltraScale+ ZCU216 - USB Interface

Figure 11: USB Interface
SM3320
USB2.0
USB
MIO
ULPI
GTR Tx, Rx
USB3
Connector
USB
GTR
X23311-100119
The USB3320 is clocked by a 24 MHz crystal (X2). See the Standard Microsystems Corporaon
USB3320 data sheet for clocking mode details.
The interface to the USB3320 PHY is implemented through the IP in the ZU49DR RFSoC
Processor System (PS). USB OTG support is available for USB 2.0. Refer to Table 3 for USB 2.0
jumper sengs.
Note: The shield for the USB 3.0 micro-B connector (J18) can be ed to GND by a jumper on header J20
pins 2-3 (default). The USB shield can oponally be connected through a series capacitor to GND by
installing a capacitor (body size 0402) at locaon C204 and jumping pins 1-2 on header J20.
The USB3320 ULPI U6 transceiver circuit (see the following gure) has a Micrel MIC2544 high-
side programmable current limit switch (U7). This switch has an open-drain output fault ag on
pin 2, which will turn on LED DS7 if overcurrent or thermal shutdown condions are detected.
DS7 is located adjacent to the USB J18 connector (Figure 2, callout 6).
The following gure shows the ULPI U6 transceiver circuit.
Chapter 3: Board Component Descriptions
UG1390 (v1.1) July 10, 2020 www.xilinx.com
ZCU216 Board User Guide 40
Send Feedback