Xilinx Zynq UltraScale+ ZCU216 User Manual

Table 24: M.2 U40 Connections to the XCZU49DR Zynq UltraScale+ RFSoC
XCZU49DR (U1) Pin Net Name I/O Standard
M.2 Connector U40
Pin Number Pin Name
AD36 GT3_SATA1_TX_P 1 49 SATA-A+
AD37 GT3_SATA1_TX_N 1 47 SATA-A-
AC38 GT3_SATA1_RX_P 1 41 SATA-B+
AC39 GT3_SATA1_RX_N 1 43 SATA-B-
Notes:
1. Series capacitor coupled, MGT I/F and I/O standards do not apply.
For more informaon, see PCI_Express_M.2_Specicaon_Rev1.1_TS_12092016_NCB on the
PCI-SIG website.
The detailed RFSoC connecons for the feature described in this secon are documented in the
ZCU216 board XDC le, referenced in Appendix B: Xilinx Design Constraints.
FPGA Mezzanine Card Interface
The ZCU216 evaluaon board supports the VITA 57.4 FPGA mezzanine card plus (FMC+ or
FMCP) specicaon by providing a subset implementaon of the high pin count connector at J28
(HSPC). FMC+ connectors use a 14 x 40 form factor, populated with 560 pins. The connector is
keyed so that a mezzanine card, when installed on the ZCU216 evaluaon board, faces away
from the board.
FMCP Connector J28
Samtec SEAF series, 1.27 mm (0.050 in) pitch. Mates with SEAM series connector. More
informaon about SEAF series connectors is available on the Samtec, Inc. website. More
informaon about the VITA 57.4 FMC+ specicaon is available on the VITA FMC Markeng
Alliance website.
The 560-pin FMC+ connector dened by the FMC specicaon (see Appendix A: VITA 57.4
FMCP Connector Pinout) provides connecvity for up to:
• 160 single-ended or 80 dierenal user-dened signals
• 24 transceiver dierenal pairs
• 6 transceiver dierenal clocks
• 4 dierenal clocks
• 239 ground and 19 power connecons
Chapter 3: Board Component Descriptions
UG1390 (v1.1) July 10, 2020 www.xilinx.com
ZCU216 Board User Guide 59
Send Feedback

Xilinx Zynq UltraScale+ ZCU216 Specifications

General

Brand	Xilinx
Model	Zynq UltraScale+ ZCU216
Category	Motherboard
Language	English