Xilinx Zynq UltraScale+ ZCU216 - USB 3.0 Transceiver and USB 2.0 ULPI PHY

Table 15: IP4856CX25 U23 Adapter Pinout (cont'd)
Aires Adapter Pin Number IP4856CX25 U23 Pin Number IP4856CX25 U23 Pin Name
22 D4 CMD_SD
23 B5 DATA3_SD
24 A5 DATA2_SD
25 C2 ENABLE
For more informaon on the IP4856CX25, see the NXP website.
The detailed RFSoC connecons for the feature described in this secon are documented in the
ZCU216 board XDC le, referenced in Appendix B: Xilinx Design Constraints.
USB0 (MIO 52-63) USB 3.0 Transceiver and USB 2.0
ULPI PHY
The USB interface on the PS-side serves mulple roles as a host or device controller. The USB
3.0 interface (host mode only) is supported by the RFSoC GTR interface while the USB 2.0 (host
and device modes) capabilies of the SMSC USB3320C controller are shared on a common USB
3.0 micro USB type A connector (J18).
USB 3.0 Transceiver and USB 2.0 ULPI PHY
[Figure 2, callout 6]
The ZCU216 board uses a Standard Microsystems Corporaon USB3320 USB 2.0 ULPI
Transceiver (U6) to support a USB connecon to the host computer. A USB cable is supplied in
the ZCU216 Evaluaon Kit (standard-A connector to host computer, USB 3.0 A connector to
ZCU216 board connector J18). The USB3320 is a high-speed USB 2.0 PHY supporng the UTMI
+ low pin interface (ULPI) interface standard. The ULPI standard denes the interface between
the USB controller IP and the PHY device which drives the physical USB bus. Use of the ULPI
standard reduces the interface pin count between the USB controller IP and the PHY device.
The following gure shows the USB 3.0 interface. USB 3.0 is host mode only.
Chapter 3: Board Component Descriptions
UG1390 (v1.1) July 10, 2020 www.xilinx.com
ZCU216 Board User Guide 39
Send Feedback