Xilinx Zynq UltraScale+ ZCU216 - User PMOD GPIO Headers; User I;O

User PMOD GPIO Headers
[Figure 2, callout 22]
The ZCU216 evaluaon board supports two right-angle PMOD GPIO receptacles J46 and J47.
The 3.3V PMOD nets are level-shied and are wired to the ZU49DR device U1 bank 88.
For more informaon on the pmod interface, visit the Digilent website.
The detailed RFSoC connecons for the feature described in this secon are documented in the
ZCU216 board XDC le, referenced in Appendix B: Xilinx Design Constraints.
User I/O
[Figure 2, callout 23, 24, and 25]
The ZCU216 board provides these user and general purpose I/O capabilies:
• Eight sets of 3 RGB LEDs (24 LEDs total) (callout 23)
○ RGB_[R,G,B]_LED_0: DS46
○ RGB_[R,G,B]_LED_1: DS47
○ RGB_[R,G,B]_LED_2: DS48
○ RGB_[R,G,B]_LED_3: DS49
○ RGB_[R,G,B]_LED_4: DS50
○ RGB_[R,G,B]_LED_5: DS51
○ RGB_[R,G,B]_LED_6: DS52
○ RGB_[R,G,B]_LED_7: DS53
• 8-posion user DIP switch (callout 23)
○ GPIO_DIP_SW[7:0]: SW14
• Five user pushbuons and a CPU reset PB switch (callouts 24 and 25)
○ GPIO_SW_[NWCES]: SW8, SW9, SW10, SW11, SW12
○ CPU_RESET: SW13
The detailed RFSoC connecons for the feature described in this secon are documented in the
ZCU216 board XDC le, referenced in Appendix B: Xilinx Design Constraints.
Chapter 3: Board Component Descriptions
UG1390 (v1.1) July 10, 2020 www.xilinx.com
ZCU216 Board User Guide 51
Send Feedback