ADPRO
®
FastTrace™ 2 Series Hardware Installation Manual
21790_05 13
2.3 FastTrace 2E
The FastTrace 2E is the latest hardware in the ADPRO® FastTrace™ 2 series. It has been developed as a
powerful video system with high performance and more efficient operation to replace the former FastTrace
units. The FastTrace 2E has up to 20 analogue video inputs, up to 32 IP video inputs, and supports up to
32 analytic channels.
Although the XOa 3 software technically allows for 32 IP channels, these 32 channels are only available on
FastTrace 2E models with an Intel DH61BE or MiTAC PH10LU motherboard, and 4 GB RAM or more. On
other models, maximum 16 IP channels are available.
Furthermore, to use the 32 IP channels, the FastTrace 2E requires a new system license. Use Xchange to
install the new license. For instructions, see Field Alert #6 – Upgrading to Xoa 3.
Remember to purchase and install additional IP licenses if required.
You can purchase the FastTrace 2E with a full or TX-only system license.
TX (transmission) only license
For more information on the system licenses, see System License on page 13.
The FastTrace 2E requires software version 2.10 or higher.
Wherever in this document the term FastTrace 2 is used, you can assume that the term refers
to both the FastTrace 2 and the FastTrace 2E, unless specifically mentioned otherwise.
2.4 System License
From version 2.00, all ADPRO video systems require a system license.
Applications such as IntrusionTrace, LoiterTrace…, IP channels, and the video encoder cards
require a separate license. They are not included in the system license.
There are 3 types of system licenses available:
FULL: all features of the video system are available.
ENTRY(*): all features are available, with these restrictions:
- You can use only 4 analogue cameras (no IP camera support).
- You can use only 1 hard disk.
- You can only use 1 MIO card (and no EIO cards).
TRANSMITTER (TX) only: all features are available, but continuous recording is not allowed and
recording on event is fixed to 5 seconds pre-recording, 10 seconds event recording, and 0 seconds post-
recording. Furthermore, event recording stops when the limit of 16,000 events has been reached.
(*) The ENTRY system license is not available for the FastTrace 2X or FastTrace 2E configuration.
A FastTrace 2 video system running without system license will behave as a video system with a FULL
license for 5 days. However, the system informs the user of the license error via the event message
0013 – [SYST] – SYSTEM LICENSE ERROR, and via a popup window at each connection with the XOa
client.
After that period of 5 days, the video system enters a locked-down state, and refuses all connections for
live streams and recordings. All active configured recordings continue on the video system. During this
locked-down state, the XOa client shows only the About window (so that you can retrieve the necessary
information to order a new license) and the Transfer window (so that you can upload a license to the
To Next Page
Loading...
Need help?
General
