Yamaha Genos2 - Page 6

6
Genos2 Owner’s Manual
CAUTION
Always follow the basic precautions listed below to avoid the possibility of physical injury to you or others, or
damage to the product or other property. These precautions include, but are not limited to, the following:
Location
• Do not place the product in an unstable position or
a location with excessive vibration, where it might
accidentally fall over and cause injury.
• Before moving the product, remove all connected cables,
to prevent damage to the cables or injury to anyone who
might trip over them.
• Use only the stand specied for the product. When
attaching it, use the provided screws only. Failure to do so
could cause damage to the internal components or result in
the product falling over.
Connections
• Before connecting the product to other devices, turn o the
power for all devices. Before turning the power on or o for
all devices, set all volume levels to minimum.
• Be sure to set the volumes of all devices at their minimum
levels and gradually raise the volume controls while playing
the product to set the desired listening level.
Handling
• Do not insert your nger or hand in any gaps on the
product.
• Do not insert foreign materials such as metal or paper into
any openings or gaps of the product. Failure to observe this
may cause a re, electric shocks, or malfunctions.
• Do not rest your weight on, or place heavy objects on the
product, and do not use excessive force on the buttons,
switches or connectors.
• Do not use the product or headphones for a long period
of time at a high or uncomfortable volume level, since this
can cause permanent hearing loss. If you experience any
hearing loss or ringing in the ears, consult a physician.
• Remove the power plug from the AC outlet before cleaning
the unit. Failure to observe this may cause electric shocks.
Yamaha cannot be held responsible for damage caused by improper use or modications to the product, or data that is lost or
destroyed.
Always turn the power o when the product is not in use.
Even when the [P] (Standby/On) switch is in standby status (display is o), electricity is still owing to the product at the minimum
level.
When you are not using the product for a long time, make sure you unplug the power cord from the wall AC outlet.
(DMI-11)