B95W
Maintenance
06_Wartung und Pflege_en.fm - V1.0 - 1.8.17
127 / 306
6
20
Daily tasks
Tab. 6-6 Daily tasks
Tasks to be carried out on a weekly basis
Tab. 6-7 Tasks to be performed weekly
Pos. Inspection Page
1 Check hydraulic oil level 167
2 Check engine oil level
134
3 Check coolant level 137
4 Check fuel pre-filter for the accumulation of water, drain if necessary 158
5 Check the fuel level (fuel gauge on operator control panel)
Check AdBlue
®
level
148
6 Check windshield washer fluid level 200
7 Visual inspection (general), e.g. for material cracks, external damage,
loosened parts, completeness, etc.
--
8 Check for leaks in pipes, hoses, control unit, hydraulic pumps, cylinders, etc.
The screw-in couplings must be locked when tightening hose or line
connectors to prevent them from turning
--
9 Check function of electrical indicating and warning elements as well as the
lighting system
187
10 Check all controls are working properly and adjust as necessary --
11 Lubricate the machine according to the lubricating chart 122
12 Check electrics --
Pos. Inspection Page
15 Clean cooling fins of the combination cooler
In case of visible dust, shorten the cleaning intervals
137
16 Check correct function of door latches --
17 Check tire pressure and wheel nuts 182
18 Check fastening of axles and propeller shaft 175
19 Check mounting of slewing drive (hydraulic motor and transmission) --
20 Check the bushings and pins of the work equipment --
21 Check hydraulic axle locking 173
22 Check correct function of pneumatic springs of service covers and front
windshield
--
23 Check function, condition and completeness of safety equipment --
24 Check “working hydraulics shut-off via maintenance cover” function --
25 Lubricate the machine according to the lubricating chart 122
To Next Page
Loading...
