B95W
Maintenance
06_Wartung und Pflege_en.fm - V1.0 - 1.8.17
135 / 306
6
20
Changing engine oil
Run the engine warm until the engine oil temperature reaches approx. 80 °C.
Park the machine in horizontal position.
Rotate the uppercarriage so that it is at an angle of 90° to the undercarriage.
Shut down the engine.
Place a suitable oil collecting vessel under the drain opening.
Unscrew the oil drain plug (4).
Screw an oil drain hose on to the oil drain plug (4).
Drain the oil and catch it as it runs out.
Remove the oil drain hose and screw the oil drain plug back on (4).
Replace the engine oil filter (3).
J See chapter “Changing engine oil filter”.
Fill in engine oil through the oil fill hole (1) until the oil level reaches the “MAX”
mark on the dipstick (2).
Start the engine and allow it to idle for approximately 2 minutes.
Shut down the engine and let it cool down.
Check the oil level and top up the oil if necessary.
To Next Page
Loading...
