B95W
Description
84 / 306
5
05_Beschreibung_en.fm - V1.0 - 1.8.17
11
Diesel particle filter - ash load (optional)
• The diesel particle filter is in use throughout the entire cycle of the ash, which is not
removed as part of a regeneration.
• Ash load leads to shorter regeneration intervals, which ultimately calls for
replacement of the filter within the scope of maintenance.
• In the case of 100% ash load, replacement of the filter is required.
Filter replacement requirement
• If, despite the engine OFF message, the engine is still in operation and the
filter continues to accumulate load - above 100 % ash load - regeneration is
no longer possible.
• At this point, the filter must be replaced.
J The ‘Ash control light’ icon (ash indicator) in the engine monitoring icon bar
flashes yellow.
Filter replacement warning
J If the filter replacement request is ignored, then the “Ash lamp” icon starts to flash
once 105 % of the ash load is reached.
• Additional loading of the filter with ash, leads to shorter regeneration intervals and
increasing exhaust gas back pressure
.
Tab. 5-9 Icon meaning
Notice
A maintenance concept has been created by DEUTZ to maintain the
exhaust particle filter system.
Maintenance is only to be performed by a qualified DEUTZ service team.
Relative ash load Level “Ash lamp” icon
< nominal load (100%) Loading OFF
> nominal load (100%) Filter replacement requirement permanent
> warning level (105%) Warning flashing
Notice
Following replacement of the filter, the soot and ash load must be set to zero
in the control unit using SERDIA.
To Next Page
Loading...
