YASKAWA U1000 Series - Page 533

B.4 Control Mode Dependent Parameter Default Values
YASKAWA ELECTRIC SIEP C710636 02B YASKAWA U1000 Technical Manual 533
Parameter List
B
<6> Default setting value varies by the drive model (o2-04).
<18> Values shown here are for 200 V class drives. Double the value when using a 400 V class drive.
<44> The default value shown here is for the following localized drives: Japan (Model code: CIMR-UA), Asia (Model code:
CIMR-UT). For default value of China localized drive (Model code: CIMR-UB), refer to Default Values of the China Localized
Drive: CIMR-UB  on page 537.
<51> This setting value depends on a Maximum Applicable Motor Capacity in models CIMR-U20248, 40156 to 40414: 2.00 in
Open Loop Vector Control, 0.05 in Closed Loop Vector Control
<52> This setting value depends on a rated output current and V/f pattern selection in parameter E1-03.
<53> The default setting value depends on the Heavy/Normal duty selection in parameter C6-01.
<69> Default setting value is determined by the drive model (o2-04).
20028 to 20248 (o2-04 = 6A to 75), 40011 to 40414 (o2-04 = 95 to AA): 1
40477 to 40930 (o2-04 = AC to B0): 3
<73> Default setting value is determined by the drive software version.
PRG: 1016 and earlier: 0
PRG: 1017 and later: 1
SIEP_C710636_02B_1_0.book 533 ページ ２０１５年１１月２５日 水曜日 午後４時５６分