15-18
IM 701310-01E
Explanation
Information such as the trigger time can be sent to a specified mail address on the
network as an action of action-on-trigger or GO/NO-GO determination.
Mail Server
Specify the IP address of the network mail server. On networks supporting WINS/DNS,
you can specify the name (NetBIOS name or domain name) instead of the IP address.
Mail Address
To Address: Set multiple recipients mail addresses using up to 100 characters.
Separate each address with a comma.
From Address: Set the sender address using up to 40 characters. If you do not specify
the sender address, the recipient address is set.
Comment
The comment is written on the first line of the transmitted mail. Enter it as necessary. You
can enter a comment using up to 100 characters.
Attached Image
The screen image shown at the time of mail transmission can be attached to the mail.
• File format: PNG
• Filename:DL_image[date/time].png(example:DL
Image0802171
158.png→dataat
11 hour 58 minutes on February 17, 2008)
• Resolution: XGA
(1024 × 768 dots)
• File size (estimate)
•
Normal screen:
Approx. 50 KB
• Maximum: Approx. 1.6 MB*
* When there is a lot of color information
User Authentication
POP3 user authentication is carried out before sending mail.
• Mode
ON: Carry out user authentication before sending mail
OFF:
Do not carry out user authentication before sending mail
• Encryption type
U/P: Send authentication data in plain text.
APOP:
Send authentication data by encrypting
• Server Name
Enter the host name or IP address of the POP3 server using up to 30 characters.
•
User Name
Set the user name using up to 30 characters that is required when accessing the
POP3 server from the DL9000.
• Password
Set t
he password using up to 30 characters that is required when accessing the POP3
server from the DL9000.
Time Out
Set the transmission/reception timeout value. The selectable range is 1 to 60 s (default:
15 s, 1 s steps).
15.4 Setting the Mail Transmission (SMTP Client Function)
To Next Page
Loading...
Need help?
General
