YOKOGAWA DLM3024 User Manual

Index-1
IM DLM3054-01EN
Index
Symbols
Page
ΔT cursor ............................................................................. 11-2
ΔT&ΔV cursor ...................................................................... 11-3
ΔV cursor ............................................................................. 11-2
λ ........................................................................................ 17-10
Numerics
Page
3 wire .................................................................................. 4-69
4 wire .................................................................................. 4-69
A
Page
A->B(N) trigger ................................................................... 4-78
Accum Time .......................................................................... 7-4
accumulation ........................................................................ 7-4
accumulation time................................................................. 7-4
ACK mode .......................................................................... 4-33
ACQ count ............................................................................ 6-3
acquisition mode................................................................... 6-2
action .................................................................................... 5-1
action count .......................................................................... 5-2
action in averaging mode ..................................................... 6-5
action mode .......................................................................... 5-1
action-on-trigger, execution .................................................. 5-3
action-on-trigger, notes on .................................................... 5-7
action to perform when the conditions are met..................... 5-1
active power ..................................................................... 17-15
active (SPI) ......................................................................... 4-70
active(user define) .............................................................. 4-72
additional options................................................................ 22-9
addition, subtraction, and multiplication................................ 9-3
address data (I2C) .............................................................. 4-65
address (I2C) ...................................................................... 4-65
A Delay B trigger................................................................. 4-77
ampere-hours ................................................................... 17-16
analysis results, saving (serial bus) .................................... 15-4
analysis source waveform (FFT) ........................................ 10-1
analyzing and searching (CAN) .......................................... 15-7
analyzing and searching (CAN FD) .................................... 15-9
analyzing and searching (CXPI) ....................................... 15-17
analyzing and searching (FlexRay) .................................... 15-5
analyzing and searching (I2C) .......................................... 15-31
analyzing and searching (LIN) .......................................... 15-14
analyzing and searching (SENT) ...................................... 15-23
analyzing and searching source waveform (serial bus)...... 15-2
analyzing and searching (SPI).......................................... 15-33
analyzing and searching, turning on and off (serial bus) .... 15-1
analyzing and searching (UART) ...................................... 15-28
analyzing and searching (user-defined serial bus) ........... 15-35
angle cursor ......................................................................... 11-4
angle unit ............................................................................. 11-4
apparent power................................................................. 17-15
applicable class .................................................................. 17-9
Area2 setting .................................................................... 12-12
area (XY) .............................................................................. 8-2
assignment .................................................................... 2-3, 2-5
A trigger .............................................................................. 4-78
attenuation constant ............................................................. 6-3
attenuation ratio .................................................................... 1-3
attributes (file) ................................................................... 20-17
auto calibration ................................................................... 22-3
auto level mode .................................................................... 4-1
automated measurement of waveform parameters, saving
results of .......................................................................... 20-6
automatic zero adjustment ................................................... 1-4
automatic zero adjustment of current probes ....................... 1-4
auto measurement, notes on ............................................ 12-13
auto measurement on/off .................................................... 12-1
auto mode............................................................................. 4-1
auto scaling .......................................................................... 9-7
auto scroll (zoom) ............................................................... 13-2
auto setup .................................................................. 4-24, 22-1
auto setup (CAN) ................................................................ 15-7
auto setup (CAN FD) ........................................................ 15-10
auto setup (CXPI) ............................................................. 15-18
auto setup (FlexRay) .......................................................... 15-5
auto setup (I2C) ................................................................ 15-31
auto setup (LIN) ................................................................ 15-14
auto setup (SENT) ............................................................ 15-23
auto setup (serial bus signal).............................................. 15-2
auto setup (SPI)................................................................ 15-33
auto setup (UART) ............................................................ 15-29
average count ....................................................................... 6-3
average (history)................................................................. 18-2
averaging mode .................................................................... 6-2
B
Page
background transparency ................................................... 19-6
backlight adjustment ........................................................... 22-8
bandwidth ............................................................................. 1-5
bandwidth limit ...................................................................... 1-5
bar graph display .............................................................. 17-10
beep sound ........................................................................... 5-1
BIN.................................................................................... App-5
binary computation ........................................................... App-5
bit and bus display order ...................................................... 2-5
bit assignments..................................................................... 2-3
bit order (SPI) ..................................................................... 4-70
bit order (UART) ................................................................. 4-63
bit pattern (CAN)................................................................. 4-31
bit pattern (CAN FD) ........................................................... 4-39
bit rate (CAN)...................................................................... 4-35
bit rate (CAN FD) ................................................................ 4-41
bit rate (FlexRay) ................................................................ 4-28
bit rate (LIN)........................................................................ 4-47
bit rate (UART) ................................................................... 4-63
bit setup ................................................................................ 2-1
Break Synch .............................................................. 4-44, 4-45
broadcasting system........................................................... 4-74
B trigger ..................................................................... 4-77, 4-78
B TRIG key ......................................................................... 4-77
bus ........................................................................................ 2-3
bus bit assignments .............................................................. 2-3
bus channel ............................................................... 4-28, 15-5
bus display............................................................................ 2-3
bus setup (CAN) ................................................................. 15-7
bus setup (CAN FD) ........................................................... 15-9
bus setup (CXPI) .............................................................. 15-17
bus setup (FlexRay) ........................................................... 15-5
bus setup (LIN) ................................................................. 15-14
bus setup (SENT) ............................................................. 15-23
bus setup (SPI) ................................................................. 15-33
bus setup (UART) ............................................................. 15-28
bus setup (User Define).................................................... 15-35
byte order ........................................................................... 4-32

YOKOGAWA DLM3024 Specifications

General

Brand	YOKOGAWA
Model	DLM3024
Category	Test Equipment
Language	English