6 - 14 TC70x Integrator Guide
• Code ID Type - A Code ID character identifies the code type of a scanned bar code. This is useful when the
reader is decoding more than one code type. Select a code ID character to insert between the prefix and the
decoded symbol.
• Code ID Type None - No prefix (default)
• Code ID Type AIM - Insert AIM Character prefix.
• Code ID Type Symbol - Insert Symbol character prefix.
• Decode Haptic Feedback - Enable the device to vibrate upon a good decode (default - False).
• Decode Feedback LED Timer - Set the amount of time (in milliseconds) that the green Data Capture LED
stays lit after a good decode. (default - 75 msec.). Move slider to change value.
• Decoding LED Notification - Enable the device to light the red Data Capture LED when data capture is in
progress. (default - False).
• Decode Beep Feedback - Select an audio tone to sound upon a good decode.
• No Beep Feedback - Audio tone does not sound.
• Hardware Beep Feedback - Audio tone is system tone (default).
• Software Beep Feedback - Audio tone is programmed by application.
To Next Page
Loading...
