11 - 6 TC70x Integrator Guide
Examples
Use the following examples to run Field Medic Helper from a command prompt. You should use Cmd-device in
TShell to run these commands from a PC.
Start QXDM, store the log on the SD card, and stop after 48 hours:
Start QXDM and store the log in C:\data\test\bin\logs:
Stop QXDM:
Start Netlog, store the log on the SD card, and stop after 10 hours:
-etw start - Start ETW logging.
stop - Stop ETW logging.
-userdump Start a user-mode dump.
-kerneldump Start a kernel-mode dump.
Table 11-2 Options
Option Description
-mode Dump mode for user-mode or kernel mode dump.
Default - Use the default dump mode.
Full - Use the full dump mode.
-storage The storage type. This cannot be used with the path parameter.
SD - Use the SD card for storage.
Phone - Use the device for storage. Default value.
-path The MTP path to store the report. This cannot be used with the storage parameter.
-timeoutduration The duration that the logging should occur in hours. By default, this is 48 hours.
Caution: If you specify a value larger than 48 hours, make sure you have enough
buffer allocation and memory.
-dmcinputpath Path to the custom DMCFile for QXDM.
-custominputpath Path to the custom profile XML file for ETW or QXDM.
FieldMedicHelper -qxdm start -storage SD -timeoutduration 48
FieldMedicHelper -qxdm start -path C:\data\test\bin\logs
FieldMediaHelper -qxdm stop
Table 11-1 Parameters (Continued)
Parameter Description
To Next Page
Loading...
