INTRODUCTION
Axio Examiner Warning and information signs at the equipment Carl Zeiss
M60-2-0003 e 05/2012 11
1.2 Warning and information signs at the equipment
Figure 1-1 Warning and information signs at the equipment
1.3 Warranty instructions
The equipment manufacturer warrants that the equipment is free from any defect in material or
workmanship at the time of delivery. Any defect which may occur should be notified immediately, and
everything should be done to minimize any damage. When such a defect is notified, the equipment
manufacturer agrees to correct such defect, at the equipment manufacturer's sole option, either by repair
or by delivering equipment which is free from defects. No warranty is granted for defects which are
either due to natural wear and tear (especially for wearing parts), or to improper handling.
The equipment manufacturer shall not be liable for any damage caused by wrong operation, negligence
or miscellaneous interventions in the equipment, especially by removing or replacing equipment parts or
by using accessories made by other manufacturers. In such an event, all warranty claims shall be void.
No maintenance or repair work may be conducted on the microscopes except for the activities as
described in this operating manual. Repair shall only be allowed to the Carl Zeiss customer service or to a
person especially authorized by the Carl Zeiss customer service. Whenever a fault occurs in the
equipment, please first call the Carl Zeiss Microscopy Service in Germany (see page 88), or your Carl Zeiss
representation if you are located in another country.
To Next Page
Loading...
