Zeiss Axio Examiner - 3 START-UP; 3.1 Installing standard components

START-UP
Carl Zeiss Installing standard components Axio Examiner
26 M60-2-0003 e 05/2012
3 START-UP
The Axio Examiner may be installed or converted, and put into operation by the customer on his or her
own. But if requested, the microscope may also be installed or converted by the Zeiss customer service
subject to a fee at the customer's premises.
Be sure to read and understand the Equipment Safety Notices carefully before you install the
microscope, or start using it (see page 8).
3.1 Installing standard components
3.1.1 Unpacking and installing the microscope
• Take all assemblies out of the package, and
check them for completeness as per delivery
note.
• Place the microscope stand (Figure 3-1/1) on a
vibration-free, level and non-inflammable
surface.
• Either store the original package to allow long-
term storage or return to the manufacturer, or
dispose of the package properly.
Figure 3-1 Installing the microscope