Setting of time
C15N110
By pressing button (A) enter the service menu
a - Use buttons (B) and (C) to select the item CALIBRATION indicated with arrow (a) and by pressing button
(A) (ENTER) you enter the CALIBRATION menu
b - Use buttons (B) and (C) to select the item SETTING OF TIME indicated with arrow (b) and by pressing
button (A) (ENTER) you enter the next screen
c - Setting time screen
1 - Setting of hours
2 - Setting of minutes
3 - Store and return to CALIBRATION menu (b)
4 - Return to CALIBRATION menu (b) without saving
5 - Display of hours
6 - Display of minutes
Procedure for setting of time
Use buttons (B) and (C) to select the item hours (1); by successive pressing of button (A) (ENTER) we
change the value of hours in the display; changes are displayed directly in the position (5).
Use buttons (B) and (C) to select the item minutes (2); by successive pressing of button (A) (ENTER) we
change the value of minutes in the display; changes are displayed directly in the position (6).
Use buttons (B) and (C) to select the item STORE AND RETURN (3) to confirm changes in the setting of
time and for the return to the CALIBRATION menu or select the item RETURN (4) to return to the
CALIBRATION menu without saving the time setting and confirm it by pressing button (A) (ENTER).
If the accumulator battery of the tractor is disconnected for a longer time, ca. after ten days the
set time is reset (zeroed). When accumulator battery is connected, the current time must be set
again.
Instrument panel - warning
Replenish fuel
When the fuel signal lamp is lit up, the appeal for
replenishment of the fuel appears in the display for about
3 seconds.
C15N061
To Next Page
Loading...
Need help?
General
