Zetor CRYSTAL Series - Initial Run-In Principles (First 100 Hours); First 10 Hours of Operation; Operation After 100 Hours

General principles of new tractor ru
n
-in in first 100 hours of operatio
n
During first 100 hours of operation:
z Load tractor in a normal way, avoid operation with low or maximum engine revolutions
z Avoid operation under partial loading of the engine
z Avoid excessive idle run operation
z Check oil levels in engine often (during this time increased oil consumption is normal)
z Check screw joints in particular in supporting parts of tractor
z Learned insufficiencies to be removed immediately, you will thus prevent subsequent damage or
endangered operation
z Keep the same procedure also after tractor complete overhaul
In first 10 hours of operation
From 100 hours of operation
A
fter drive in com
p
letion
y
ou can work with tractor without limitations
.
z perform run-in in traffic
z tighten fastening nuts of front and rear wheels including
connectionbead / rim with prescribed torque
C15N013
RUNNING IN THE TRACTOR
87