Common Tasks
9650-001355-01 Rev.M X Series Operator’s Guide 2-21
Set Date and Time Screen with Clock Synchronization
For systems with the Clock Synchronization feature enabled, the Set Date and Time screen
indicates the date and time of the X Series last synchronization to an external time source and
allows you to adjust the clock for Daylight Saving Time. You can choose whether to enable
Daylight Saving Time or not by selecting the Enable/Disable DST field as appropriate.
Adjustments to Daylight Saving Time take effect immediately and must be manually adjusted
at every transition between Standard Time and Daylight Saving Time. If enabled the clock will
be adjusted forward by 1 hour. These fields only display on systems with the Clock
Synchronization feature enabled. For information on Clock Synchronization, see “Configuring
Clock Synchronization” on page 22-30.
Changing the Display Brightness
The following procedure shows how to select the different brightness options.
1. Press the power switch to turn the unit on.
2. Press the Brightness quick access key ( ) repeatedly to toggle through the brightness
options until you find your selection.
Note: Selecting a higher brightness setting (such as 70%) will deplete the battery pack at a
faster rate than when choosing a lower brightness setting (such as 30%). To select the
brightness setting, go to the Setup>Display/Volume>Display Brightness menu to
adjust the display percentage.
To Next Page
Loading...
Need help?
General
