Zte ZXR10 2900E Series - Single-Port Loop Detection Configuration; Set Loopdetect Sendpktinterval

ZXR102900ESeriesCommandReference
Example
Thefollowingexampleshowssummarycongurationsonallports:
zte(cfg)#showpoeconfig
port|enable|max-power|priority|extend-detection|force-power
1disable15.4wlowdisabledisable
2disable15.4wlowdisabledisable
3disable15.4wlowdisabledisable
4TRbind15.4wlowdisabledisable
5TRbind15.4wlowdisabledisable
6disable30.0wlowdisabledisable
7disable15.4wlowdisabledisable
Thefollowingexampleshowsthedetailedcongurationsonport4:
zte(cfg)#showpoeconport4
port:4
configtime-range:t1
max-power:15.4w
priority:low
extend-detection:disable
force-power:disable
4.37Single-PortLoopDetectionConguration
4.37.1setloopdetectsendpktinterval
Purpose
Thiscommandsetstheintervalthatloopdetectsendspackets.
CommandMode
Globalcongurationmode
Syntax
setloopdetectsendpktinterval<5-60>
ParameterDescription
ParameterDescription
<5-60>Interval(seconds)thatloopdetectsendspackets.
Guidelines
Theintervalthatloopdetectsendspacketsissameforallports.
4-538
SJ-20130731155059-003|2013-11-27(R1.0)ZTEProprietaryandCondential