Chapter 6 System Management
Confidential and Proprietary Information of ZTE CORPORATION 63
6. In the [BootManager] state, use the command tftp to
upgrade the version. The following shows how to download
the version file from the TFTP server to the FLASH memory:
[BootManager]:tftp 10. 40. 89. 78 kernel. z
Loading. . . done!
[BootManager]:ls
snmpboots. v3 35
startcfg. txt 1378
running. cfg 231916
kernel. z 1311339
[BootManager]:
7. In the [BootManager] state, execute the command reboot
to restart the switch by using the new version. If the
switch is started normally, use the command version to
check whether the new version is running in the memory.
When the switch is not started normally, it indicates the
version upgrade fails. In this case, repeat the above
upgrade procedure.
E
ND OF STEPS
Software version upgrade has been completed.
Result
To Next Page
Loading...
