Chapter 7 Wireless
VMG8924-B10D/B30D User’s Guide
104
7.6 The WMM Screen
Use this screen to enable Wi-Fi MultiMedia (WMM) and WMM Power Save in wireless networks for
multimedia applications.
Click Network Setting > Wireless > WMM. The following screen displays.
Figure 37 Network Setting > Wireless > WMM
Register Enter the PIN of the device that you are setting up a WPS connection with and click Register to
authenticate and add the wireless device to your wireless network.
You can find the PIN either on the outside of the device, or by checking the device’s settings.
Note: You must also activate WPS on that device within two minutes to have it
present its PIN to the VMG.
Method 3 Use this section to set up a WPS wireless network by entering the PIN of the VMG into the client.
Select Enable and click Apply to activate WPS method 3 on the VMG.
Release
Configuration
The default WPS status is configured.
Click this button to remove all configured wireless and wireless security settings for WPS
connections on the VMG.
Generate
New PIN
Number
If this method has been enabled, the PIN (Personal Identification Number) of the VMG is shown
here. Enter this PIN in the configuration utility of the device you want to connect to using WPS.
The PIN is not necessary when you use WPS push-button method.
Click the Generate New PIN button to have the VMG create a new PIN.
Apply Click Apply to save your changes.
Cancel Click Cancel to restore your previously saved settings.
Table 24 Network Setting > Wireless > WPS (continued)
LABEL DESCRIPTION
To Next Page
Loading...
