Chapter 8 Home Networking
VMG8924-B10D/B30D User’s Guide
131
8.6 The STB Vendor ID Screen
Set Top Box (STB) devices with dynamic IP addresses sometimes don’t renew their IP addresses before
the lease time expires. This could lead to IP address conflicts if the STB continues to use an IP address that
gets assigned to another device. Use this screen to configure the Vendor IDs of connected STBs, which
have the VMG automatically created static DHCP entries for them when they request IP addresses.
Click Network Setting > Home Networking > STB Vendor ID to open this screen.
Figure 52 Network Setting > Home Networking > STB Vendor ID
The following table describes the labels in this screen.
8.7 The Wake on LAN Screen
Use this screen to turn on a device on the LAN network. To use this feature, the remote device must also
support Wake On LAN.
You need to know the MAC address of the LAN device. It may be on a label on the device or in its
documentation.
Click Network Setting > Home Networking > Wake on Lan to open this screen.
Figure 53 Network Setting > Home Networking > Wake on Lan
Table 34 Network Setting > Home Networking > STB Vendor ID
LABEL DESCRIPTION
Vendor ID 1~5 These are STB’s Vendor Class Identifiers (DHCP option 60). A Vendor Class Identifier is usually
used to inform the DHCP server a DHCP client’s vendor and functionality.
Apply Click Apply to save your changes.
Cancel
Click Cancel to exit this screen without saving.
To Next Page
Loading...
